COOLIT3000
Series FAQ'S
How
loud is the COOLIT3000 Series?
Does the unit
make water? What happens with the condensate?
How often will I
need to empty the tanks?
How large are the
condensate tanks?
What if I need to
run my COOLIT unit 24/7?
How long can the
condensate line be?
Do I need to vent
the unit to the outside?
How far can I
duct the unit?
What kind of
maintenance is required?
What do I need to
do if I am going to store the unit?
COOLIT3000 Series Application FAQ'S
How large of an
area can I cool with the COOLIT unit?
How cold can I get
my LAN room?
Can I put the
COOLIT unit on my UPS?
Can I plug into an
extension cord?
Do I need a
dedicated circuit to run the COOLIT unit?
What other
accessory items do I need for my application?
Who can I get to
install my COOLIT unit?
Who Has Purchased
Portable Air Conditioners From ADAPT Inc?
COOLIT3000 Series FAQ'S
How loud is the COOLIT3000 Series?
The COOLIT units are designed for indoor applications and we use advanced
compressor technology to further reduce mechanical noise. The blowers or fans are all
centrifugal type and reduce the air noise of the unit. The dB rating for this unit varies
because of the installation methods but is typically less than 58 dB.
TOP OF PAGE
Does the unit make water? What
happens with the condensate?
Yes, the COOLIT3000 Series is a true air conditioner and some moisture is
removed from the air, which results in condensate. The condensate collects in the
condensate tanks located behind the front door. When the tanks fill up, the unit will shut
off to prevent condensate overflow.
TOP OF PAGE
How often will I need to empty the tanks?
Condensate generation is based on various temperature and humidity levels
as well as user installation and control settings. In the warm, humid summer months the
amount of condensate generated will be greater than in the cool, dry winter months.
TOP OF PAGE
How large are the condensate tanks?
There are two internal condensate tanks which each hold approximately 2.5
gallons, for a total of 5 gallons. When the tanks are full the COOLIT unit will shut
off to prevent condensate overflow. You must empty the tanks and properly reseat the tanks
in the compartment before the unit will operate.
TOP OF PAGE
What if I need to run my COOLIT unit 24/7?
The COOLIT3000 Series has a built-in condensate pump that can be used to
allow continuous uninterrupted cooling. The pump has a 15’ lift capability which will
get you up to the drop ceiling level and allow for connection to a drain line.
TOP OF PAGE
How long can the condensate line be?
The COOLIT3000 Series has a built-in condensate pump that comes with 25'
of 3/8" plastic tubing. You may require more tubing than what is supplied with
the pump. You can either attach the new section of tubing to the supplied tubing
with a coupler or purchase a new section of tubing to fit the required length of your
condensate drain line. You can go as far as you need to with the tubing as long as
you keep the tubing sloping down at an angle. Again, if you need to go a long
distance to your drain, we recommend that you go up as much as you can (up to 15') then go
towards your drain with the tubing sloping down at an angle.
TOP OF PAGE
Do I need to vent the unit to the outside?
No, you do not need to vent the COOLIT3000 Series to the outside. If you
are cooling an enclosed equipment environment you do need to discharge the condenser air
(warm air) out of the space you are trying to cool. The warm air duct is built-in to the
top of the unit, and allows for condenser air discharge into the ceiling plenum area, out
a window, or through a wall.
TOP OF PAGE
How far can I duct the unit?
The warm air duct that comes with the COOLIT3000 Series is enough to reach
the ceiling of a standard commercial building. You can add a few more feet of ducting but
you must keep your duct run as straight as possible.
TOP OF PAGE
What kind of maintenance is required?
Unit maintenance is quick and easy. The COOLIT3000 Series has a totally
sealed refrigeration system. It should not be necessary to recharge your unit. The only
regular preventative maintenance is cleaning/replacing the filters. If you have been using
the automatic condensate pump system, you need to keep the drain line clear.
TOP OF PAGE
What do I need to do if I am going to store the
unit?
Before storing the unit you want to ensure the evaporator coil is dry and
the condensate is emptied from the tanks. First you would operate the COOLIT3000 Series in
the fan mode for about 5 minutes to dry out the evaporator coil and get all the moisture
off of the coil. Turn the unit off, empty the condensate tanks, and wipe down the cabinet
with a soft cloth and mild detergent. Your COOLIT unit will be in prime shape when your
next cooling need arises.
TOP OF PAGE
COOLIT3000 Series Application FAQ'S
How large of an area can I cool with the COOLIT
unit?
That depends on what is in the area you are trying to cool. All air
conditioning units are rated in BTU, or British Thermal Unit, which is a unit of measure.
There are 12,000 BTU to 1 ton of air conditioning. For equipment cooling we need to
determine the amount of power being used by the equipment in the room so we can do a basic
heat load calculation.
TOP OF PAGE
How cold can I get my LAN room?
There is no way to tell. The COOLIT3000 Series will give you approximately
a 20°F temperature differential – for instance, if your room is 80°F, the unit will
deliver approximately 60°F air. This does not mean that your room will be 60°F. . . that
all depends on the heat load in the room.
TOP OF PAGE
Can I put the COOLIT unit on my UPS?
Absolutely, as long as the UPS is properly sized.
TOP OF PAGE
Can I plug into an extension cord?
We do not recommend that you operate the COOLIT3000 Series using an
extension cord. If an extension cord is required, use a cord rated at least 20 amps
at 250 volts with a grounding type attachment plug and grounding type connector (load
fitting).
TOP OF PAGE
Do I need a dedicated circuit to run the COOLIT
unit?
The COOLIT3000 Series is a mechanical device and could potentially put
noise onto the line when the compressor starts and stops. A dedicated line is not required
but would certainly be recommended if your computer and electronic equipment is not
protected by a UPS or surge suppresser.
TOP OF PAGE
What other accessory items do I need for my
application?
The COOLIT3300 model comes complete with the integral
expandable/retractable warm air duct system for the condenser air. The standard ducting
kit allows you to duct the warm air into the drop ceiling area, a return air duct, out a
window, or through a wall. The COOLIT3000 model allows you great flexibility for
ducting the cold air and warm air. This model is easily adaptable with standard
fittings and duct available from many supply stores.
TOP OF PAGE
Who can I get to install my COOLIT unit?
The COOLIT3000 Series is designed for quick set-up. IF YOU CAN
UNPACK THE BOX, YOU CAN SET UP THE UNIT. Installation requires no tools; accessory
parts simply slide in place or snap together. If you elect to use the optional condensate
pump you may require the services of a handyman or plumber, to run your condensate drain
line.
TOP OF PAGE
Who Has Purchased Portable Air Conditioners From
ADAPT Inc?
Just a few companies who depend on ADAPT to cool their hot spots.
TOP OF PAGE
